Kwik Klamp 2 – Pipe Clamp

KWIK KLAMP 2

For Pipe Sizes 2 1/2″ – 4″

The heavy duty KWIK KLAMP 2 is the driller’s answer for holding the larger pipe sizes 2 1/2″, 3″, and 4″. KWIK KLAMP 2 is an enlarged version of our popular KWIK KLAMP 1 which is for pipe sizes 1″ through 2″, with many of the same features.

KWIK KLAMP 2 Details:

• Main body is constructed of 2″ and 2 1/2″ 1/4″ wall steel tube.

• Easy to operate, over center locking of jaws when downward pressure is applied to a 19″ long lever handle.

• 1/2″ safety pin used to prevent accidental unclamping.

• Weighs only 30 lbs. and is 20″ long x 7 1/2″ wide.

Capabilities

Holding 4″ PVC Pipe

Holding 4″ Pipe on 12″ Casing

3″ Steel on 8″ Casing

2″ Pipe

The Drillers Answer

KWIK KLAMP 2 allows workers to bring pipe or drill joint up to an easy working level. The jaws are equipped with 16 carbide tipped gripper bolts. Designed to hold pipe sizes 2-1/2″, 3″ and 4″ (2.875″OD-4.5″OD) PVC, HDPE, stainless and galvanized.

The KK 2 has excellent holding capabilities with loads over 7,000 lbs.
KK2 Load Test Report: ESP026328P J&K Tool KK2 Final

The KWIK KLAMP is one of the safest time saving tools you will ever own.

An additional jaw set can be purchased to extend the holding capacity of the Kwik Klamp 2 down to 2″ pipe (see below).

KK2 Removable Jaw Set

Especially designed for holding 2″ and 2 1/2″(2.375″OD – 2.875″OD) pipe using the Kwik Klamp 2.

Increased holding capacity for PVC and galvanized pipe.

*Jaw sets are not intended for bare steel drill rod.*

[Set of 4 serrated hardened jaws with bolts.]

KWIK KLAMP 2 Spacers

Additional (4) spacers can be purchased to accommodate 4 1/2″ pipe (4.950″ OD). Spacers will be placed on the middle two jaw pads on each side.